Guangdong Sanwood Technology Co.,Ltd
Guangdong Sanwood Technology Co.,Ltd Aim to be the world's Well-known Brand for Environmental Reliability Test Chambers and Battery test chambers
Add to Cart
EN60529 IP5X IP6X Sand Dust Test Chamber Dustproof Test Chamber
Sand Dust Test Chamber, also known as "dust chamber", it simulates the destructive effect of natural wind and sand climate on products, and is used to test the sealing performance of product shell. It is mainly used for IP5X and IP6X tests.
The whole air duct is made of imported high-grade stainless steel plate, the bottom of the air duct is connected with the conical hopper interface, the air inlet and outlet of the fan are directly connected with the air duct, and then the diffusion port on the top of the working room is connected to the working room body at an appropriate position to form an "O" type closed vertical dust blowing circulation system, Make the air flow smoothly, make the dust disperse evenly to the maximum extent. A single high-power low-noise centrifugal fan is used, and the frequency converter is used to adjust the wind speed according to the test requirements.
Sanwood Sand Dust Test chamber Specifications
| Item | SM-SC-2000 |
| Internal dimension | 1000W*1000D*2000Hmm |
| External dimension | 1400W*1650D*2900H mm |
| Chamber material | SUS304 Stainless steel |
| Specifications of square mesh sieve | Mesh hole 75um, mesh metal wire diameter 50um |
| Talcum powder amount | 2 ~4 kg/ m2 |
| Airflow speed | No more than 2m/s |
| Door | Left open door with tempered glass door |
| Controller | PLC Touch Screen controller a. Blowing dust time (Stop/Blow) m/s b. Cycle time: can be adjusted c. Pre-set test time: 0s ~99m99s |
| Vacuum system | Pressure gauge, air filter, Pressure regulating FRL, connecting pipe, Vacuum pump |
| Fan | Centrifugal fan |
| Safety protection devices | Meter over-temperature function, Phase shortage protection, Power short-circuit protection |
| Power supply | Standard: 380V AC, 50Hz three phase Power supply vailable for the other countries in the world. |
Structure and features
1. The double-layer lithium ion batteries thermal aging test chamber, is composed of the two chambers, heating systems, air circulation system and circuit and control system.
2. The double-layer lithium ion batteries thermal aging test chamber is made of high quality SUS#304 stainless steel material,the outer shell adopts A3 steel plate,surface electrostatic coating.
3.Insulation system uses superfine fiberglass wool or polyurethane foam so as to ensure the temperature of inside chamber.
4. Temperature sensor: Class A type PT100 sensor.
5. The chamber equip with two separate control system. Each chamber can be operated independently so as to reduce the cost of testing, extend the operating life of the machine and decrease the failure rate.
6. Powerful multi-wing type air circulation which can ensure even temperature distribution inside the working chamber.
7.With larger transparent viewing window and lighting inside to observe the test.
8.Standard configuration with one test hole on the left side of the chamber for easy testing operation and temperature measurement; Can be equippe with more test holes to battery charge or discharge testing.
9.With various of safety protection device such as leakage and outage protection,compressor overpressure protection,overload fusing protection,audio signal alarm.
10. With various of explosion proof safety devices, according to your test needs after compared to the EUCAR Hazard level or USCAR.
Product Catalog:
Dust Test Chamber.pdf